Elko L3033 dimmer button inner body

Repairs Elko L3033 light button by adding additional structure inside of existing button. It will look exactly the same as original part, but will function much better and last longer.

Print part from ABS or ASA because it needs to handle heat. Use 4-5 perimeters and 20% infill. Layer height should be 0.2mm.

1. First remove any residue / plastics which are still attached into know (picture shows cleaned state before attaching printed part)
2. Test fit part to shaft (4mm). Use drill bit or file to make it fit properly
3. Test fit part to button and use sand paper if needed
4. Glue printed part inside of the button
5. Attach back to light dimmer 
6. profit!

Prepare original button (remove all old plastics which hold shaft in the middle)