Phone stand

So everyone has to make a phone stand at some point. This one works with large phones and is easy to print. I like it best sliced with fuzzy skin (as pictured), but if you opt for that is up to you ;)

• Stable even with large phones (pictured with a phone measuring 75mm * 160mm)
• Works with charger (hole for routing at the back and front is open)
• Sturdy (no problem to just slam the phone down 100 times a day like me)
• 3mm thickness
• No supports needed.

Print instructions

• Tested with 0.2 layer height. 0.4 nozzle.
• Print lying down on the side