Creality K1 X Carriage Cable strain relief for softer and shorter springs

This mod was created to replace stock springs with softer ones. It's hard to find springs with the same lengths so I changed cable strain relief to compensate smaller length of the springs.

Stock spring: 

wire diameter: 0.8mm 

length: 12mm outer 

diameter: 5mm

Current mode is for 0.4mm wire 15mm length springs. It helps to reduce vibrations on X.

Print settings:

Perimeters\top\bottom 4+

Filament: ABS and stronger 

After running PETG part for couple of months it distorted a lot due too temperatures and force applied. Reprinted with ABS, so far no issues.

Assembly:

1. Remove extruder cover by unscrewing 2 screws, 1 on each side (bottom)
2. Unscrew original cable strain relief, 2 screws
3. Remove original springs
4. Install new springs
5. Install new cable strain relief (printed part)
6. Install extruder cover
7. Done

Cable strain relief was adjusted to be used with softer and shorter springs.