The Snap Latch snaps into a locked state when it is pressed towards the box front and it passes over a retaining tab. To open the box, pull the latch past the retaining tab and lift the box's lid.
This cartridge box is printed as separate parts that are printed in orientations chosen to maximize strength and then snapped together.
The box halves require moderate infill (10%-20%) and can be printed with no supports, but I prefer to paint on supports under the flat sections on the latch hoops and the latch catches. I printed with 0.16 layer height in PLA.
Do not use Perimeter Generator: Arachne on the box bottoms.
Assembly instructions:
Push the tabs of the latches through the latch hoops on the box lid until the latch tabs fully lock in place.
Category: Tool Holders & Boxes
The author marked this model as their own original creation.