No Support Charging Stand

An elegant phone charging stand that does not require the use of support material to print.

This will hold regular and XL sized phones up to 12mm thick, tilting them back 25 degrees.

v12 update: Stand is 6mm taller to allow for less flexible charging cables, slightly thicker to reduce bounce, and offers 1mm more depth for phone cases.  I've also removed the side chamfers to make it easier to print, but a brim is still highly recommended.

Print instructions

Printed in PLA, 0.2mm layer height, 4 perimeter walls, 50% infill.

Print on it's side with a brim.