I recently picked myself up an OmniVap XL and have been loving it, but I wasn't able to find any containers that I really liked for it.
Inspired by some other knurled containers I saw on Thingiverse, I decided to try to design my own. I really like the texture of the knurling, and the threads are really smooth so it doubles as a pretty good fidget toy.
If your tolerances are off, it might be helpful to scale the part up or down in small amounts using your slicer.
There are a ton of different DynaVap models out there, but from what I can tell they all fit into one of four sizes.
This includes most "M" models and the non-XL OmniVap. Fits max height of 92mm.
Same width as the "M" size, but a little bit taller. This mostly applies just to the OmniVap XL, but could also apply to "M" models with a mouthpiece. Fits max height of 109mm.
The VonG shares the same height as the M, but is wider to accommodate the wooden midsection.
Same width as the VonG and same height as OmniVap XL. This will fit VonG XLS models, but probably not XL models with an added mouthpiece.
Notes:
This print should be pretty forgiving with whatever settings you throw at it. I was successful with layer heights between 0.15 and 0.3. PETG is recommended if you're handling a hot dynavap, but if you let it cool before putting it in this container then you should be good with PLA.
About reselling this model:
I don't have a problem with people selling prints of this container, as long as you leave a link here in you description.
The author marked this model as their own original creation. Imported from Thingiverse.