SKR 2 Ender 5 Plus Mount

Wanted to put my BIGTREETECH SKR 2 board in the middle of the open space in my Ender 5 Plus to have access to all sides of the inputs, including the USB port for a Raspberry Pi running Klipper, but Kersey Fabrication's mount pressed the inputs up against the case, so remixed my own. First time doing something like this, and there's still some unnecessary artifacts from my quick hob-job.

Print Settings

Printer: Creality Ender 5+

Rafts: No

Supports: No

Resolution: .2

Infill: 100%

Filament: eSUN PLA+

Notes: 210 degrees

I took the 1.4 Turbo mount into Tinkercad and duplicated it. Measured where I needed the new posts and moved it down that far. Took some hole blocks to remove the old posts, and joined the two together.