infil speed test and top chell layer test for bambu studio and orca slicer

how to use:

top chell layer test : the best looking value is the one that u should use

infill speed test: check the bottom of the print look for things like cooling problems cracks in the infill walls or underextrusion. if any of these are seen use a lower value

warning it may not print at full speed from to low acceleration. slower printers may not even be fast enough

( this test is limited to your printers capabilities)

to make sure your printer is running the infill at the fastest speed that your printer can achieve you can change this setting:

this test is made for bambu studio and orca slicer