A simple door hanger with rounded corners to prevent snagging of garments and a reinforced middle section designed to be as resource efficient as possible while increasing load bearing capacity. 6 months worth of testing this model with backpacks and heavy bathrobes up to 4kg resulting in zero deformations.
Requires a 3mm clearance between top of the door and door frame.
Print settings:
K1 Max
PLA
0.2 layer height
20% infill
3 walls, 3 top and 3 bottom layers
print it on its side
no support needed
brim recommended
print time - 23 min with first layer at 60mm/s then 280mm/s for the rest
The author marked this model as their own original creation.