Sitting Unicorn with Eyes (remeshed + flat base)

After downloading the model and prepping it for printing by cleaning up some of the surface variations from the original scan, I noticed what seemed to be the faint outlines of little eye dots, perhaps painted or even glazed on. So I tried sculpting them out a little bit and I thought it looked cute enough to reupload!

Printed on an Ender 3v2 in basic gray PLA. The wings and chin need support material. The bottom edge of the flattened surface is slightly rounded, so if smaller supports aren't enabled during printing, extra cleanup may be required.

Remeshed the original model, cleaned up mild surface imperfections, deepened/sharpened some fine details, flattened the bottom for easier printing, and added/accentuated eyes on the model.