Klean Kanteen Kids Bottle Clip

At my kids kindergarten a lot of kids have the same bottle from Klean Kanteen and since the kids mix them up a lot I decided to design a tag. You can simply add the name of your kid in the slicer. 

Print without supports 0.2mm layer height, print with at least 3 perimeter so there is no infill (and more stability). Prints in like 15min on a MK4 without a name engraved.

I recommend printing in PETG since it is a bit more flexible and waterproof. PLA should work too if you dont have PETG. 

Feedback is very welcome! 

Enjoy :)