Two Trees Bluer Plus dovetail mount for Pi models

I needed somewhere to mount a BTT Pi to a Two Trees Bluer Plus 3D Printer.  

Started the design with the mount to the printer utilizing the existing screws. Then added the dovetail horizontally to the mount.  The mount will be flush to the bottom of the printer, and when the bottom panel is on it will have a gap.

Tested with the OrangePiLTS3 dovetail model, and I will be using the BTT Pi 1.2 from the following:

https://www.printables.com/model/863832-bigtreetech-btt-pi-12-case-for-wall-mount-or-2040

https://www.printables.com/model/424711-orange-pi-3-lts-case-wall-mount-dovetail-style

Printed in Esun Blue PLA Pro, 0.4 nozzle, 3 walls, 3 bottoms, 4 tops, and 20% infill.

**I don't know if this works with their non-plus model.  Spacing for the screws are 70mm between the bottom 2 holes, the other screw is 16mm right, and 20mm up from rear bottom screw.

Created a side mount of the dovetail to mount to the Two Trees Bluer Plus printer