Created after my daughter came home from Emerald City Comic Con 2024 with some
prints she wanted on her wall.
These are low profile hanger brackets for prints in common protective plastic
sleeves. They are designed to detract from the art itself as little as possible
and print without supports. The actual hanger hardware is 10mm diameter (or
less) thumbtacks (I bought mine at Micheals). The thumbtacks are recessed so
that the head of the tack doesn't deform the back of the prints.
The thick holder slots are 1.8mm and the thin holder slots are 1.6 mm. I found
these sizes hold 2mm thick protectors and 1.8mm protectors nice and snug.
You can print 2 bottom corner and 2 top corner pieces for an "open top"\
configuration that can make it a little easier to hang, or just print 4 bottom
corner pieces for a more symmetric look (See pictures).
I printed these with PLA at 0.2mm layer heights.
The author marked this model as their own original creation.