samurai hueforge

samurai hueforge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x193.12mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Orange Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA PolyLite White Transmission Distance: 5
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #14 (1.2mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow

Border Only Colors from here until the end.
At layer #18 (1.52mm) swap to White for the rest.