Prusa XL Heavy Duty Camera Mount

Two adjustment brackets are included for use with and without the Prusa Enclosure. When installing the adjustment bracket to the enclosure, do not over-tighten the bolt as it goes into plastic only.

The mounting hole for the camera is ¼" or 6mm for standard camera mount options. In the picture I used https://www.amazon.com/dp/B081N6GH3N 

Filament: Prusament PLA

Infill: 20% Gyroid

Walls: 3

Hardware needed: (1) M3nEs**, (3) M3x 10-12mm and their washers. (2) M6x30, 4 washers, 2 lock washers, 2 nuts. 
**You should have one extra M3nEs from the spare parts included with the Prusa XL, if you need more you can fine them here: https://www.prusa3d.com/product/psu-holder-m3ne-2/