Fiat engine compartment cable clip

I was in need of a specific kind of cable harness clip, but was unable to find the exact part number. So I designed and printed a replacement part myself. It is meant to snap into elongated slots of roughly 6x12 mm at a material thickness of around 1.5mm.

Original was made from nylon, a material that is demanding to print. I made mine from PETG instead, that has sufficient flexibility for the task and hopefully withstands the thermal and chemical conditions inside the operation environment.

It seems to fit the intended purpose (and fixture points) so far. Long term performace and reliability it not yet proven!

Optimized for .4mm nozzle size. Tiny bit of support material is required at lower part.