Govee Outdoor Lights Pro 2-hole mounts.

Set of two mounts for the Govee permanent Christmas lights Pro pucks.  

One mount has the added feature of a light shield to block direct view of the light lens from most viewing angles.

I printed 15 at a time in a Bambu X1 Carbon, I'm sure you could print faster or get more on the plate but the regular version is about 3Hr print time, version with shield is about 4Hr per 15/plate.  

• Fixed geometry on the mounting tab, original was not on centerline of the part.
• Fixed screw mount holes to better fit #6 flat head screw.
• Added second mounting tab to stop mount from twisting out of plane when attached.
• Gave more clearance to wire hole, original mount pressed down on the wire.
• Added height to the body, original did not account for the 3M adhesive.
• Reduced ID of the body to tighten the fit around the light pucks. 
• Added second version with light spill shield.  This will block the direct view of the lens from most viewing positions.