SB2209 two PCB mount for orbiter 2 compatible with SB, TAP

quick way to connect two pcb canbus to existing orbiter 2. I had to unscrew orbiter motor and put it so that motor wire comes from the top and then insert it into sb2209 due to very short cable of the orbiter. You can use two regular voron heat set inserts to mount the sb2209 on the panel. you should use some either printed or metal spacers to mount it from motor. I replaced the stock orbiter 2 m3 bolts with longer ones to support a printed spacer. please note that this setup would change your axis map in klipper config.

changed the back mount to support SB2209 rp2040, for the actual mount I am using voron sb + orbiter 2 mount check remix for the mount