Hex Foldable Sitting Mat and Table ARCHIVED OLD MODEL

Around 50 cm width design made for hiking. 

You can use it as a mat to sit on or a table to put on anything.  I cared about lightweight yet sturdy design with minimal use of supports and post process, that can be easly attached to backpack, so thats why its hexagonal. 

Because of a size I made one file that contains whole object  and folder with alternative assembly by parts, since not everyone has big enough printer. 

I suggest choosing hard material such as PETG, PLA or ABS with around 20% infill and high detail.

Whole version should be printable without supports, the joints that are foldable are the only sensitive thing and they may require supports, depending on used material. 

(you can skip reading if you can print 50 cm version) 

Parted version (picture below) requires more supports and assembly (glue may be helpful), but its only for people with small printers. It should be easy, you only need to connect sides by numbers and at the end put caps on snap in hexagonal supports that hold foldable attachments. Enjoy!