Nintendo Switch Cartridge holder/insert (Fits all cases)

Nothing special, personally I printed using a 0.4mm nozzle using dynamic layer height to get the best quality/speed.

The original v2 design was great but had two issues for my use case. Firstly you had to damage the case by cutting off the document tabs, secondly it would not fit the EU/International style Nintendo Switches which had a slightly different design with an extra bit of plastic at the top of the case.

This remix deals with these by making the following alterations:

1. Two of the cartridge slots on the left side have a cut out allowing you to slide the document tabs over the top. This reduces the number or carts you can store to 10 from 12 but it also makes the insert stay firmly in place.
2. I reduced the height of the insert by a few mm, it will now fit in both styles of Nintendo Switch case.

Note this design is based on the “v2” version which has much better hold on the carts making them less likely to fall out. He also added the divots to make removing them easier. The other similar remix was based on the v1 revision which is missing all his v2 improvements.

Updates

V2 - Original Release 
V3 - Allow more room for the plastic clips