Garmin watch band strap

A replacement part for a Garmin watch wrist band. The original strap that secures the loose end failed.  I made this replacement with a similar peg to keep it from sliding around. It is slightly thicker than the original, but I've not noticed the difference. 

I moved the post from the center to the edge so it would print without supports.  TPU can be problematic with supports so I tend to design them away as much as possible. 

Printed wirh Ninjatek Cheetah TPU. Prusa has the settings. The only change i made was adding a perimeter to create a solid print.  0.2mm layer height for strength.