Small on-head filament cutter for flashforge adventurer 5M
I did it as small as I could.
V2 is even smaller but you would need supports.
301
1528
7
7923
updated
September 1, 2024
Description
PDFadventurer 5M
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
I did it with 9mm cutter blade, insted of 18mm so it's much smaller. You can even install it without removing the drag chain.
You would need:
- A pair of retractable ball pen springs (I used just one long enough to cut it into two pieces)
- A pair of 3x25mm screws.
- 25mm of PTFE tube.
- A piece of 9mm cutter blade (the small ones).
The v1 has a beveled flat face that you can use to lay on the bed for a better printing
The v2 is even 4mm shorter (this is the one I prefer), but you would need supports.
The main body should be printed with a rotation in the X-axis of -135º. This is the best printing orientation for better strength and less supports (no supports at all with v1).
Don't know if it can be a problem with the 5M printed enclosure. Check the picture with the extruder in the front edge.