Ergonomic Cock Ring - warped donut

Designed another ergonomic cock ring model but this time with donut-style (ellipse) cross sections versus using beveled/filleted inner surfaces.  I believe this is my best design yet and have worked very hard on/with it.

This cock ring was designed for use around the cock and balls together. 

It features:

- a flared fit which stays tight as you get harder and harder but does not dig in or pull the skin.

- a contour to fit closely against your body.

- a non-circular design that contacts your genitals all the way around to minimize pressure points.

- extra room for the urethra so it doesn't fight against your ejaculate.

The diameter range goes from 40 mm to 55 mm in 1 mm size increments.  The size is equivalent to what you would wear for a round ring (e.g. metal rings).  The width (distance along your shaft) is about 18 mm at the widest point but varies around the ring.

To put it on correctly, the smaller diameter side of it goes towards your body, and the bottom of it has the little dipped shape for the urethra.

DQP