Venom Pro Magazine Extender

I made this remix after printing the mini-talon extender FetteWorst made and realizing it needed some tweaking to work with the Venom Pro mag.

The spring in the Venom Pro mag is too short to support the 5 extra dart capacity. It is possible that it would work to size it to be 4 extra darts, but decided on 3 to bring the capacity up to 15 to match Nightingale mag size.

The Venom Pro mags have a notch at the bottom on each side. I added tabs on the inside so that the mag will click into these notches to help hold onto the magazine and not rely on a friction fit.

PRINT SETTINGS 

Infill: 0%
Layer Height: .20
Walls: 3
Supports: None

UPDATE 8/29/2024

Updated the stl file as there was an issue with the original that the spring would catch and not allow the follower to slide into the extender. I named the file “venom-pro-mag-extender-fix” to help determine the difference if you downloaded the original.

This is a remix of “Mini_Talon_Magextender+5_smooth_TPU+0.0.STL” version.

Reduced the height by 26mm to support 3 darts instead of 5 as the venom pro spring is too short to support the height of 5 extra darts.

Added tabs to the inside to hold the venom pro magazine in place as the nightingale mags don't have this attachment point.

Cut out some extra material on the inside as there was some overhang on the sides that was allowing the spring to catch and not allow the follower to slide into the extension.

Removed the bottom ridge as I prefer a slimmer profile.