Safety Clip to Secure Monitor Riser to Rolling Wire Cart

I've got a monitor shelf on a rolling cart with a wire top. A slight knock could bump the monitor shelf off.

These safety clips, one at each corner, secure the shelf so a slight bump won't knock it off.

Since you probably don't have the same brand of cart and shelf that I do, I've included shelfclip.scad a text file in openSCAD format where you can enter the dimensions of your cart and shelf to get the custom brackets you need.

Print instructions

Category: Office Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Filament: monoprice PLA black
Notes:

I did a test print with 1 clip, 1 perimeter, vase mode to verify the fit.

To make the clips strong I used 4 perimeters. Otherwise, just the default print settings.

Post-Printing

Installation

Press the bottom edge of the clip to shelf first, then rotate it to lock into place flush with the cart's top surface. Then slide the clip into place, grabbing the monitor shelf.