Linear Snuff Accelerator v3 - Snuff Box - Schnupftabakschleuder

Snuff box with build in catapult.
New Version with a dent, for a more easy lever movement (only visible on the renderings, not the real photos).
I prited it in PLA with a 0.35mm nozzle, 0.20mm layer height and a honeycomb infill of 0,20.

Instructions

• Print the three parts.
• Sand the bolt and the inner channel of the top part until they are smooth.
• Sand down the sides of the bolt pin if necessary (depending on your printer it can be too wide and didn't fit in the slot).
• Put the bolt in the top part following by a spring.
• Put the snuff in the chamber of the top part.
• Close the top part with the bottom part.