Porsche Taycan Phone Holder

This holder conceals the charger cable and attaches to the cup holder without requiring any modification or disassembly of the center console. It can be installed and removed instantly, yet is stable enough to keep the phone in place while driving. It supports any MagSafe-compatible phone/ cover with a maximum length up to that of the iPhone 15 Pro Max. The phone can be placed in either portrait or landscape position.

Instructions:

1. I used the following MagSafe charger: https://amzn.eu/d/c8PZjAe .  You can use any charger with a maximum diameter of 55.50 mm and a depth of approximately 6 mm. For chargers with different dimensions, the model size will need adjustment. If you require other dimensions, please let me know in the comments.
2. Stick anti-slip pads/ tape on the bottom edges of the base to secure it in the cup holder, otherwise the unti will get pulled out when lifting the phone. I used some that I had lying around (see the attached picture). Similar ones can be purchased on Amazon: https://amzn.eu/d/8HQWjPL
3. I have intentionally kept the slide connector between the base and the top bit tight. It may be a bit difficult to slide in the first time. Use a small amount of grease or sand the groove slightly and carefully connect the parts. Slide them a few times to make the connection smoother. The connector allows for slight gap adjustments between the holder and the armrest to accommodate different phone case sizes.
4. I wrapped the holder in carbon film to give it a professional look and to avoid the need for fine-quality printing or sanding. You can use any film, print in fine quality, or sand and paint it, according to your preference. :-)

Printer Settings:

• Printer: Creality K1 series
• Filament: Creality Hyper PLA
• Quality: Normal / 0.20 mm
• Infill: 15%
• Infill Pattern: Grid
• Print Time: approx. 90 mins
• Rafts/ Supports: none

I'd appreciate your comments, reviews, and feedback.

Enjoy and have fun!