Gridfinity Stand for Brother P-Touch 550 Labelmaker (2 pieces, 1x3 each)
Remix of the 6x3 part, split in two 1x3 parts, added magnet cutouts and modified it to allow printing while stored.
5
37
1
180
updated
September 10, 2024
Summary
PDFRemix of the 6x3 part, split in two 1x3 parts, added magnet cutouts and modified it to allow printing while stored.
Tags
Model origin
The author remixed this model.
Differences of the remix compared to the original
- Split in two small 1x3 parts (vs. the original 6x3) removing the empty 4x3 center section to save filament/print time and added magnet cutouts.
- Reduced size of the stop for the top part to allow printing while it is sitting in the stand.
- Widened the cutout for the top end of the printer, it was a bit too tight for a nice fit (+3mm).
- Changed floor height of both parts (+4mm on the low end, -4mm on the top end) for better fit and slightly lower height overall.
- Removed the lip running around the perimeter.
