Samsung Galaxy Fit3 charging station / Samsung Galaxy Fit 3 Ladestation / Зарядная станция Samsung Galaxy Fit3 / Подставка для Samsung Galaxy Fit 3

Samsung Galaxy Fit3 charging station / Samsung Galaxy Fit 3 Ladestation / Зарядная станция Samsung Galaxy Fit3
12
121
3
622
updated December 24, 2024

Description

PDF

This model was created for Samsung Galaxy Fit3. This is a stand into which the original charging cable is inserted and it becomes a charging station.

S_1-L. This is a model with a notch for the logo.

S_1. This is a basic model without a notch for the logo.

S_2V. This model is attached from above, and a clock is hung on it.

S_3. This model is inserted from the back and covers the wire.
 

FOR PRINTING, I RECOMMEND:
Layer 0.2
Nozzle 0.4
To print the basics. at the top, where there is a difficult place with spikes and protrusions, I recommend setting a minimum variable layer. You can do without it, but it's better this way)
There is a variable printing layer for the logo. The lower part of the logo is 0.2 and the upper part is 0.08.
If possible, the nozzle is 0.2.

The inspiration was a model from the author @bosondehiggs, which he redesigned from a model by another author who was not specified. In turn, I did reverse engineering and redesigned the model, adapting it to FIT 3

If it's not difficult, offer your options and suggestions. Please tell us what you liked and what you would change In the comments!
As soon as there is time, I will upload the changes to the same card :)

RU____________________________________________________________________________________________________

Данная модель созданная для Samsung Galaxy Fit3. Это подставка в которую вставляется оригинальный зарядный кабель и она становится зарядной станцией.

S_1-L. Это модель с выемкой под логотип.

S_1. Это модель основы без выемки под логотип.

S_2V. Это модель крепится сверху, на нее вешают часы.

S_3. Это модель вставляется сзади и закрывает провод.


ДЛЯ ПЕЧАТИ РЕКОМЕНДУЮ:
Слой 0,2
Сопло 0,4
Для печати основы. верха где присутствует сложное место с шипами и выступами рекомендую выставить минимальный переменный слой. Можно обойтись без этого но так будет лучше)
Для логотипа переменный слой печати. Нижнюю часть логотипа слоем 0,2 а верхнюю 0,08.
Если есть возможность сопло 0,2.

Вдохновением служила модель от автора @bosondehiggs, которую он переработал от модели другого автора который не был указан. В свою очередь я сделал реверс инжиниринг и переработал модель, адаптировав под FIT 3

Если не сложно предлагайте свои варианты и улутчения. Пожалуйста расскажите что вам понравилось и что бы вы изменили В комментариях!
Как будет время я залью изменения на эту же карточку :)

Tags



Model origin

The author marked this model as their own original creation.

License