DT3D SKINNING UP BOX

my gf needed a box for her rolling stuff. original files include my first iteration of the dt3d skinning up box. the slots beside the grinder caddy is to store 20 deck of cigs upright. the grinder caddy si for the generic grinder off amazon. and you have the typical rizla store underneath the sliding rolling tray.

I have also included an experimental file for the lid which does work however is a bit thin as i have put an image inside the lid. so if printed in pet g. this should look awesome. has room to hold the dt3d dank plank I have also attached with the file and has a j tube holder for the cheeky one smokers club joint holder.

I am going to change this design and add the v2 files as this box is specific for my partner and the equipment she uses. i will soon be making one suitable for the larger grinders. a 50g tobacco pouch and specific cutouts for roach books and such 

use 1.75mm filament for the hinges and the latch where it attaches to the box. but use a metal m3 x however long bolt for the latch latch on to.

the loose filament int he hinges in the photo are because this is still a prototype and will be getting changed out immediately … I recomend just using a clipper. softening up the ends of the filament hanging out the ends of the hinges, and roll the flat with the metal shield of the clipper

… updated. lid v2 and base v2 now has a stopper so the lid doesnt open all teh way. it stops just past 90