MOD-FINGERZ MINIATURE FREESTYLE PARK [STARTER PACK]

[5/16/25] UPDATE: Full version now free for all.  This post will be left up for now, but just go download it here: 

https://www.printables.com/model/1297163-mod-fingerz-minature-freestyle-park 

The park layout was inspired by the Enoshima BMX Park featured in the Olympics.  
The fully printed park spans (approx.) 57cm [22.4"] by 48cm [18.9"] and features an innovative connection scheme allowing for simple park expansion and piece rearrangement.  

DESIGN UPDATE - REVISION A (2-12-2025):
Geometries have been updated to include alignment sockets and corresponding pegs to improve connection between pieces (see new drawing sheets 4 & 5 and photos). New course pieces are compatible with original pieces by using original connector rings (without pegs).

Additionally, detailed dimensions are now shown for connection scheme (see drawing sheets 4 & 5), if creators want to design their own compatible pieces that will connect to the ones published here.

PRINTER SIZE REQUIREMENT: 
- FDM printer able to accommodate pieces approximately 190mm X 160mm X 180mm in size is required.

STARTER PACK (FREE): 
The starter pack posted here provides pieces four (4), five (5), seven (7), eight (8), and ten (10), per the drawing.   These pieces form a cohesive section of the park and can be reoriented relative to each other or expanded upon.  For example, pieces seven (7), eight (8), and  ten (10) can be printed multiple times and connected together to form an elongated half pipe.

Full Park now released: 
https://cults3d.com/en/3d-model/game/mod-fingerz-miniature-freestyle-park

FEATURES:

- No-support design for ease of printing. Prototype was successfully printed without supports. 
- 5 printable pieces (4 ramp pieces & 1 connector pieces).
- less than 1 kg of filament to print (if using recommended settings below).
- Innovative connection scheme that provides piece modularity: arrange pieces in any orientation and/or print duplicate pieces to uniquely increase park size. 
- Splined ramp geometries for realistic feel.

RECOMMENDED PRINTER SETTINGS: 
- 2 line wall count (minimum)
- 3 layers for top & bottom surfaces (minimum)
- 5% infill (minimum)
- lines or grid infill type

The prototype was printed using the above print settings on an Ender 3 S1 Plus.

FUTURE CONTENT:
Additional designs are currently being developed that may be compatible to expand the Freestyle Park posted here. Your support and feedback are greatly appreciated.

PN: PR3DBMXOGS00

VERSION: A