Gridfinity Nikon Z mount horizontal lens holder

Nikon Z (should work for F mount as well) mount horizontal lens holder for the gridfinity system. There are 1x3, 2x3, 3x3 versions of this holder depending on the length of your lens allowing you to mix and match parts to fit your lens. There are end cap versions of each length to prevent lenses from sliding out of their position. This allows it to accommodate lenses ranging from a 70-200mm to the 180-600mm.

Each gridfinity square is 41.75mm (~1.64in) long or 39.75mm (~1.56in) for the end cap if you want to measure your lens to determine the length you'll need.

This is meant as a companion to my vertical lens holders here. 

I printed mine out in PETG .6mm @ .2mm layer height with 10% infill. Feedback and comments welcome!