BTT TMC5160T Pro AWD + MCU Board mounting bracket for Octopus and Manta M8P

This is a MCU Board mounting bracket for Octopus and Manta M8P that holds 4 BTT TMC5160T Pro drivers for AWD Mods/VZbot. 

BOM:

    20X M3*4*5 Heat set inserts

    20X M3*8 SHCS (If using the fan cases in the picture then 16X M3*10 and 4X M3*8)

Two mounting methods:

6X M2 self tapping screw holes for standard Voron DIN mounting methods. This one still follows the “MCU in the middle of the DIN” design to minimize obstruction of other existing components.

3X M4 BHCS (You can use SHCS but it sticks out by 2mm) holes between the TMC5160 and the MCU for “Wall mounting”. The holes are spaced 65mm apart from each other, Would recommend putting a 1-2mm TPU or silicone spacer between the bracket and whatever you are mounting it on to reduce vibration and heat buildup.

A big thankyou to Buttermilk Crispy Chicken Salad for the TMC5160T Plus fan case design.