Pickguard for Aria Pro II The Cat Electric Guitar

The tip of the original pickguard on my guitar cracked and broke off near the jack. I was not able to find a replacement so I decided to make my own. I cut the pickguard into two parts because it is too large to fit on the print bed of my Prusa MK3.5 in its entirety. Using the PLA and 0.2mm Speed profiles in Prusaslicer 2.8, it took about 90 minutes to print the larger part and 30 minutes for the smaller part. I hope this might be useful for other guitarists out there who have the same guitar. 

Using PLA will work but I've found that certain brands of PLA have a tendency to disintegrate after a few years so I would suggest using a more durable material such as PETG instead.