Sennheiser MD 441 Microphone Desk Stand inspired by MZT 441

This is a desk stand for the classic Sennheiser MD 441 microphone. I wanted it to look like the original MZT 441 stand you could buy for the microphone, but since I didn't have one myself I modeled it after reference images. Still, from the photos it seems pretty close to the original one!

I'm using it with the official MZQ 441 clamp for the mic, however I believe it was made to be compatible with the original (transparent plastic) stand, so it should probably work with that too!

You will need to secure the clamp using a 5/8" microphone screw. I used this one (which I remixed from 3Dn00b's screw to include a handle) since I didn't have one at hand. I wouldn't trust it with this expensive mic in a hanging setup, but for this stand I'm sure it'll work just fine.

At the bottom of the model you have four indents for 8mm rubber pads. These are of course entirely optional, but will improve the whole model by a lot!

I'd recommend printing the stand upside down, with its top surface on the print bed, that way you won't end up with ugly layers at the top since it's slanted.

You need to use supports at the hole for the clamp!

The original sketch is available here in case you wanna make some tweaks.

Model in photos printed with Overture Matte PLA black.