Pendant Slide Ocarina

I will publish new Ocarinas only on MakerWorld.

https://makerworld.com/en/@E.CAN3

This is a funny little toy.

So… this ocarina is not in a specific tune.

It is loud and annoying.

It is fun to play.

How to use it:

Close the slot with a finger of your right hand for the lowest note.

Slide your chosen finger to the right to increase the pitch + blow a little bit harder.

Don't block the soundhole on the back!

I print them with:

• 0.4 mm nozzle
• 2 walls
• 0.2 mm Layer hight
• 4 Top and Bottom layers
• Wall Ordering: Outside To Inside - Walls before Infill.
• 20% Infill - Gyroid
• 5mm Brim
• No Support

Important

• Make sure your bed adhesion is good, else it will fail, so… clean your bed before printing!
• Avoid stringing
• Avoid Z-Seam on the labium
• Have fun!