The upper lamp body needs support (in my opinion) everywhere, because of the large overhangs (See picture).
The rest should print fine
Glue the Diffusors first (if you use them) and then join the upper and lower half of the lamp with glue. Add LEDs and a way to power them (i will add a ESP32 with WLED software) and then glue on the stand
The author remixed this model.
Since this Lamp wasn´t printable as is, I scaled it up to 150x150 and split the lamp in to parts that can be glued afterwards. The Stand is also scaled up and should fit.
The Diffusors are OPTIONAL, I included them because I want to use a WS2812b LED Strip in the Middle of the lamp, so diffusor should spread the light more equally. They are glued after printing the upper lamp body.