The Pit (Lars homestead)

The pit for Lars homestead. It's the biggest single thing I have printed. I used a large shelf to build the pit on top of. It required a lot of filling to cover the gaps between sections and to add the texture to all the walls. Most sections can be printed without any support but some do require a little. 

You should be aware these files are an absolute mess! I have got them all to slice in PrusaSlicer but can't say for others slicers. If you want to modify them you would probably be better to just start afresh.

!!! Warning the pit is particularly bad. Please make sure you slice all parts of the model before printing any. I don't want you to waste a load of filament. !!!

This is part of a larger project where I built Lars homestead as a backdrop for photos of a Lego landspeeder. The other parts of the project can be found below:

Entry dome - https://www.prusaprinters.org/prints/98051-entry-dome-lars-homestead 

Workshop top - https://www.prusaprinters.org/prints/98118-workshop-top-lars-homestead 

Droids - https://www.prusaprinters.org/prints/98160-eg-6-and-wed-15-droids-lars-homestead 

Vaporators - https://www.prusaprinters.org/prints/98157-vaporators-lars-homestead 

Assorted props - https://www.prusaprinters.org/prints/98303-mixed-props-lars-homestead

Key ring - https://www.prusaprinters.org/prints/98203-stormtrooper-keyring

Project video -