Cooler grid for separating water

Cooler grid to be put on bottom of the cooler to keep your food and drinks from getting wet. 

This grid will raise things inside your cooler for 25mm (about an inch) to allow accumulated water to stay away from the food and drinks etc. that you have in your cooler.

Grid can be sized in the slicer to fit your cooler or if you have a big cooler, you could print multiples and attach them together with zip ties. 

You can also change the height of the grid, if you want more or less room for the water under it.

Best way to print this grid is upside down. That way you don't need any supports.