Mixed props (Lars homestead)

A whole mix of basic props used to decorate a Lars homestead project. Could be used for table top gaming. Other than the mushroom shaped one they should all be printed as is and without support. Turn the mushroom one upside down to print.

You should be aware these files are an absolute mess! I have got them all to slice in PrusaSlicer but can't say for others slicers. If you want to modify them you would probably be better to just start afresh.

This is part of a larger project where I built Lars homestead as a backdrop for photos of a Lego landspeeder. The other parts of the project can be found below:

Entry dome - https://www.prusaprinters.org/prints/98051-entry-dome-lars-homestead 

Workshop top - https://www.prusaprinters.org/prints/98118-workshop-top-lars-homestead 

Droids - https://www.prusaprinters.org/prints/98160-eg-6-and-wed-15-droids-lars-homestead 

Vaporators - https://www.prusaprinters.org/prints/98157-vaporators-lars-homestead 

The pit - https://www.prusaprinters.org/prints/98353-the-pit-lars-homestead 

Key ring - https://www.prusaprinters.org/prints/98203-stormtrooper-keyring

Project video -