Defa Termini II floor stand

Floor stand for Defa Termini II 1400w car heater. 

Needed one for this winter and my car doesn't have fixed mount possibility for it. Local shop asked 18eur for piece of plastic, so I designed it myself and made it even better than the OEM one. Probably works fine with the larger Termini models too, haven't tested.

Has 3 parts: 

1. Clip to Defa heater. Similar but not exactly the same as the real one, optimized for this use, but could be used for fixed installation too with little modification. 

2. Base plate

3. Stand

I superglued the base plate + holder. Clip to stand is meant to be used with M3 16-20mm bolts and nuts. Bolt goes between clip and Defa, nut goes to stand side.

I used PETG as the heater gets warm on outside too. Tested with running it +23C room for some time without any problems, so is safe in subzero car or cold rooms etc. But I would not use PLA anyway, wouldn't want one of these deforming during use.

Print everything laying flat, 3 perimeters. Supports needed for one of the legs and the clip part. see pic.