Octoprint Relay Box

A box to hold a 5v relay module that allows Octoprint to turn your printer on/off. Comes with a V slot rail to mount onto most printers built with aluminium extrusions. Designed for the Ender-3

Parts Needed:

• 1x Relay Housing.stl
• 1x Lid.stl

2x Strain Relief.stl

• 2x M3*6mm (Relay Board)
• 4x M3*12mm (Strain Relief)

4x M3*10mm-18mm (Any length between 10mm-18mm for the lid)

• HW-482 Relay Board (You can find under other names by searching 'Arduino Relay Board 5v')

This was designed with socket head type screws in mind, but might work with others.

Thanks to Landonbayger for the Ender-3 STL and saving me the hassle of opening Fusion.

Disclaimer:
This 3D model for a relay enclosure is intended for users competent in handling electrical systems. It is primarily recommended for switching the power supply's DC output. Switching AC power with this enclosure should only be done by individuals experienced with mains electricity and aware of safety standards. The creator is not liable for any damage, injury, or loss from improper use, including misuse, incorrect assembly, or inappropriate voltage application. Use at your own risk.