Stellated Dodecathing - Highlights and Smaller scale enabled

I love Frenshape's Dodecathing and wanted to add a little extra flare to the spans.  I also filled in the endcaps so I could scale down the prints if desired.  

I've been able to print successfully at 60% with the new endcaps but I've not tested smaller than that.  Pictures show 100% vs 75% and 60%.

Recommend Arachne  for the high lighted spans if printing below 100%.

I added some pin striping to the dodecathing spans.  I also filled in the endcaps allowing me to scale down the prints without worrying about them being too fragile.