Connect 4 Travel

Traveller's connect 4 to play with your friends (you have friends right?).

Easy to print model requiring no supports*. 

Can fit on just about any 3D printer, including the Prusa Mini, A1 mini, etc.

Requires a little bit of superglue for assembly. 

It may take a bit of effort to connect the frame to the base for the first few times. But after some time, the locking mechanism will wear down enough so that it shouldn't need to much effort. You can sand down the notches on the frame a little bit if you wish.

Print:

• 1 base
• 1 of each frame (they're slightly different)
• 21 of each token colour

Use your default print settings. No supports needed*. 

Printable in PLA, but you may use PETG or other filaments if you want.

*Note: there are 2 small cantilevered overhangs on the base. These are very small (about 4mm) and most printers will have no problems printing them.