Wind whale

Garden wind whale for visual wind speed and direction display.

You will need to print all the parts included exept the stand that is optional. You can use the stand, or you can put wind whale on top of any round pole that is under 15mm in diameter.

Dome is quite large and you may need to print it in two parts to fit on the print plate. 

Scoop you will need to print 4 pieces.

Axle and arms will need to be glued together as well as scoops to the arms. I used super glue, but any plastic compatible glue works.

In addition to 3D printed parts you will need 4pcs of screws to attach Axlecover. I used size M4x30 but you could modify as needed. For M4 size the holes in axlecover will need to be drilled with 4mm bit.