Bambulab "new" anti vibration feet

Flexible feet that will minimize the vibrations your printer gives of to its surounding. Perfect for if you have multiple printers on the same table so the vibrations of one printer don't interfear with the print quality of the other printer, given the resonance compensation. Or for if your printer is on your working desk and the vibrations are anoying during your work. 

Print instructions:

• Print in flexibel material, TPU or TPE.
• Print without support.
• Advice using ‘sequential’ printing in your slicer to minimize stringing.

Aplication:

Remove the stock feet from your P1 or X1 printer. This might take a little convincing as they are glued on. After what you can place these feet in, can be done both with and without glue, given your preference. All that needs to be done now is redo all the calibration steps of the printer and you will be good to go. 

As some comments also describe I scaled it down to 95%. After wich I added the top geometrie the 'new anti vibration feed’ from Bambulab now come with. This should help keep the feet in place on your printer.