MPCNC Primo SnapOn Drag Chain Support

Since the table I built my MPCNC Primo on was a very tight fit I needed a different place to mount the cable chain on.

I took the existing feet and designed a snap fit holder around it which is enough to support an aluminum angle extrusion and the chain.

Disclaimer: This works because I didn't increase the hight of the machine. If you have longer feet there is no groove to snap into.

How to mount: Simply push the holder around the leg (it'll bend but not break) and snap it into place. Then secure it with a zip tie. Don't tighten this too hard or the holder might break. There is no need to make it super tight, you'll see.

PS: I also included a step file if someone needs to make a modification.