Ooni Koda 16 leg extension (probably also Koda 12 and Karu)

I wanted a higher working height, therefore I designed these extensions for the Ooni Koda 16 that gives a vertical lift of around 75 mm.

Added a second version with two 4 mm holes for screwing it down to a table

Prints without supports in PETG. Legs stay cool when oven is on full flame so it works out with PETG. 

V2 has a tilted foot (to not use too much space on the surface it stands) and gives a total vertical lift of 140 mm. Still very sturdy.