Alien Smoker

This was experimental model trying to mix fluorescent PLA

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA BambuLab Basic Black
• PLA PolyTerra Army Blue
• PLA Overture Purple
• PLA Ziro Fluo Lime Green
• PLA Ziro Fluo Yellow
• PLA BambuLab Basic Jade White

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Army Blue
• At layer #10 (0.88mm) swap to Purple
• At layer #13 (1.12mm) swap to Lime Green
• At layer #20 (1.68mm) swap to Yellow
• At layer #21 (1.76mm) swap to Jade White for the rest.