Prusa MK3 MK3S LightBar

Here's my new LightBar. It fits nice on the MK3 Frame and you can adjust the angle of the LightBar to get a good illumination.

The cable is guided in one of the arms.

I've printed it in Prusament Orange PETG to match the other Parts.

You need a 10mm LED Stripe and four M3x20 Screws with Nut's. I've insert a 24V LED-Stripe wich is controlled by my octoprint.

Print instructions

No Supports needed !

Let the Bar cooldown on the Headbed to ensure a straight bar. If you print it in PLA the Bar will bend down because of the "heat" of the LED-Stripe. I've printed it in Prusa PETG Orange.